User`s guide

40NetBotz Appliance User’s Guide
Motion mask tab. The following controls are available:
To unmask a masked region, click and drag in the image to draw a box around the region you want to
unmask. Click Unmask Selection to remove the mask from the selected region. Red Xs displayed in the
selected region are removed.
Click OK to save your changes. Click Cancel to close the Camera Motion Configuration window
without saving any changes.
Block out mask tab. The following controls are available:
• Enable Block Out Mask: Check to enable the Block Out Mask function.
• Block Out Mask: Specify regions of the image that are not visible in the camera image.
Use the Block Out Mask to configure your camera so specified areas of the image cannot be seen. To
mask a portion of the image:
1. Click and drag to draw a box around the region you want to ignore. Click Mask Selection to
mask the selected region. A blue block appears in the region to be blocked.
2. To unmask a region, click and drag to draw a box around the region you want to unmask. Click
Unmask Selection to remove the mask from the selected region. Any portion of the blue block
out mask that you selected is removed.
3. Click OK. Click Cancel to close the Camera Motion Configuration window without saving
any changes.
Field Description
Enable Camera Motion Check to enable the camera motion sensor.
Sensitivity Specifies how much change in a portion of the image capture is
tolerated before the change is considered movement. Lower values
indicate higher sensitivity and less tolerance for change between
images.
Show outline of detected motion When enabled, any region of an image that indicates motion is
surrounded by a dotted-line outline. This feature is not available
with Pelco cameras.
Area of Motion Specifies how large an area of the image capture must change
(based on the Sensitivity value) before the change is considered
movement. Lower Area of Motion values indicate higher sensitivity
and smaller areas.
Motion Detection Mask Specify regions of the image to be ignored by the Camera Motion
sensor.
To mask a portion of the image, click and drag to draw a box around
the region to ignore. Click Mask Selection. Red Xs appear in the
region.