User`s guide

7NetBotz Appliance User’s Guide
Simplified Basic View on Your PDA
NetBotz appliances support a simplified version of Basic View for that can be viewed using a Personal
Digital Assistant (PDA).
Accessing the simplified Basic View
To use the simplified Basic View, enter the hostname or IP address of the appliance in a supported PDA
Web browser.
• If the Guest account of the appliance is configured with a Sensor (No Camera), Sensor,
Application, or Administrator privilege set, you are automatically granted access to the
appliance.
For more information, see “Users” on page 101.
• If the Guest account is configured with a privilege set of None, you must provide a User ID and
Password to access the appliance. Log in to continue.
Using the simplified Basic View
The simplified Basic View shows only a single region of the Basic View interface at any time.
When you log in, the Navigation pane is displayed. From this pane, you can navigate to the appliance
and sensor data. Using the PDA pen, select About to display information about your appliance and
connected pods, or select the appliance or other component to switch to the Sensor Data view for the
selected item. From the Sensor Data view, you can access graphs, alert reports, and camera images.
Select Back to return to the Navigation pane from the Sensor Data view.
Viewing graphs. To display a graph of environmental data collected from a sensor, select the sensor
reading for the sensor. By default, a graph displaying data collected over the past 60 minutes is shown.
Use the Time drop-down list to change the amount of data to be graphed. Select Refresh to refresh the
contents of the graph. Select Back to return to the Sensor Data view from the Graph view.
Viewing alerts. To display a list of alerts for a selected component, select an Alert reading from the
Status column to switch to the Alerts view. A list of alerts reported by the component is displayed. To
include alerts that occurred in the past 24 hours but that have been resolved, check Include Returned to
Normal Alerts in the Alerts View. Select Back to return to the Sensor Data view.
For additional Alert details, select any of the alerts listed in the Alerts View. Select Back to return to the
Alerts view.
Viewing camera images. To display the images captured by a camera, select the camera pod or the
appliance from the Navigation pane, and select the camera link from the Sensor Data view. By default, a
camera image in 160x120 mode is displayed. To change the display mode, select a new setting from the
Mode drop-down list. To change the rate at which the image is updated, select a new setting from the
Rate drop-down list. Select Back to return to the Sensor Data view.