User`s guide

92Network Management Card User’s Guide
tcpip
[-S [enable | disable]]
[-i <IP address>]
[-s <subnet mask>]
[-g <gateway>]
[-d <domain name>]
[-h <host name>]
tcpip6
[-S [enable | disable]]
[-man [enable | disable]]
[-auto [enable | disable]]
[-i <IPv6 address>]
[-g <IPv6 gateway>]
[-d6 [router | stateful | stateless | never]]
tls
[-p]
[-a [enable | disable]]
[-m <slave # in hex> <call cause mask in hex>]
[-t [primary | secondary] <telephone #>]
[-si <# of connected UPS><slaveID1 in hex>...]
[-id <slave ID in hex> <id>]
[-d <delay in seconds>]
[-test [appearance | disappearance] <bit position>]
[-initstr [apc | mge | <any other string>]]
[-dialstr [apc | mge | <any other string>]]
[-resettodef]
uio
[-rc <dI> [open | close]
[-st <port # | port #]]
[-disc <port # | port #]]
ups
[-input [<phase#> | all] [voltage | current | frequency | all]]
[-bypass [<phase#> | all] [voltage | current | frequency | all]]
[-output [<phase#> | all] [voltage | current | load | percload | pf | frequency | all]]
[-batt]
[-about]
[-al [c | w]]
user
[-an <Administrator name>]
[-dn <Device User name>]
[-rn <Read-Only User name>]
[-ap <Administrator password>]
[-dp <Device User password>]
[-rp <Read-Only User password>]
[-t <inactivity timeout in minutes>]