User`s guide

USER’S GUIDE

Metered Rack PDU

network, the Wizard prompts you to enter an IP address that is not in use. Enter a

correct IP address, and click Finish.

5. If the Wizard finds another unconfigured Rack PDU, it displays the screen to enter

TCP/IP settings. Repeat this procedure beginning at step 3, or to skip the Rack

PDU or device whose MAC address is currently displayed, click Cancel.

Configure or reconfigure the TCP/IP settings locally

1. Contact your network administrator to obtain valid TCP/IP settings.

2. Connect the provided serial configuration cable from an available communications

port on your computer to the serial port of the card or device. Make sure no other

application is using the computer port.

3. From the Start menu, launch the Wizard application.

4. If the Rack PDU is not configured, wait for the Wizard to detect it. Otherwise, click

Next>.

5. Select Locally (through the serial port), and click Next >.

6. Enter the system IP, subnet mask, and default gateway for the Rack PDU or device,

and click Next >.

7. On the Transmit Current Settings Remotely screen, if you check-mark Start a

Web browser when finished, the default Web browser connects to the Rack PDU

or device after the Wizard transmits the settings.

8. Click Finish to transmit the TCP/IP settings. If the IP address you entered is in use

on the network, the Wizard prompts you to enter an IP address that is not in use.

Enter a correct IP address, and click Finish.

9. If you selected Start a Web browser when finished in step 7, you can now

configure other parameters through the Web interface of the card or device.