User`s guide

®
USER’S GUIDE
Metered Rack PDU
66
SNMP Trap Test (Administration>Notification>SNMP Traps>test)
Last Test Result. The result of the most recent SNMP trap test. A successful SNMP
trap test verifies only that a trap was sent; it does not verify that the trap was received
by the selected trap receiver. A trap test succeeds if both of the following are true:
• The SNMP version (SNMPv1 or SNMPv3) configured for the selected trap receiver is
enabled on this device.
• The trap receiver is enabled.
• If a host name is selected for the To address, that host name can be mapped to a
valid IP address.
To. Select the IP address or host name to which a test SNMP trap will be sent. If no
trap receiver was ever configured, a link to the Trap Receiver configuration page is
displayed. (If a trap receiver was deleted, or was reset to its default values by this or
any other management application, the default values for its trap type are listed.)
Remote Monitoring
You can register online for the APC Remote Monitoring Service (RMS). APC RMS is a
professional service that monitors your power systems and surrounding environment
from a remote operation center, 24 hours a day, 7 days a week. Through the APC RMS
Web Site, you can instantaneously modify the way APC responds to your device
events. The APC RMS Web site can also be used to retrieve information concerning
your equipment and system events at any time from any place where you can access
the Internet.