Specifications

40kW InfraStruXure PDU—Operation and Configuration 55
How to Add Circuit Breakers and Power
Cables
Add a circuit breaker on the PDU
1. Move the clip on the back of
the breaker to correspond to
the phase to which you are
connecting to (L1, L2, or L3).
2. Snap the new single-pole
circuit breaker into position
on the panel.
3. Remove the corresponding
plastic blanking plate on the
front panel of the PDU.
Add a power cable to the PDU
Before adding a power cable, add a circuit breaker.
1. Install a strain-relief connect in
any available knockout on the roof
of the PDU.
2. Slide enough of the power cable
through the strain-relief connector
to reach the new circuit breaker.
3. Tighten the strain-relief connector.