Specifications

Communication Configuration
48 40kW InfraStruXure PDU—Operation and Configuration
3. Use Telnet to access the PDU at its newly assigned IP address. For example:
telnet 156.205.14.141
4. Use apc for both User Name and Password.
5. See “Control console” on this page to finish the configuration.
Control console
After you log on at the control console, as described in “Local access to the control console” on
page 47 or “Remote access to the control console” on page 47:
1. Choose Network from the Control Console menu.
2. Choose TCP/IP
from the Network menu.
3. If you are not using a BOOTP or DHCP server to configure the
TCP/IP settings, select the Boot Mode menu. Select Manual boot mode, and then press
ESC to
return to the TCP/IP menu. (Changes will take effect when you log out.)
4. Set the System
IP, Subnet Mask, and Default Gateway address values.
5. Press C
TRL-C to exit to the Control Console menu.
6. Log out (option 4 in the Control Console menu).
Note
If you disconnected a cable during the procedure described in “Local access to the
control console” on page 47, reconnect that cable and restart the associated service.