Specifications

40kW InfraStruXure PDU—Operation and Configuration 43
Configuring the Network Management
Interface
Connect the PDU to your network
1. Connect a Cat-5 network cable to the ethernet port on the PDU user connection plate.
You can make connections from
inside the enclosure, or you can
remove the user connection plate
and make your connections.
Remove the plate using a Phillips
or standard screw driver to loosen
the two captive screws. Use the
knockout in the plate to route
cables to and from the user
connections on the plate. If you
remove the plate, make sure that you do not disturb the existing connections.
2. Run the connected Cat-5 network cable through the knockout in the user connection plate to
your network connection.
3. Configure the TCP/IP settings of the PDU. See “Configuration Overview” on page 44 for
further instructions.
Warning
Disregard the procedures in this section if you have APC InfraStruXure Manager
as part of your system.