Specifications

PDU Display Interface
40kW InfraStruXure PDU—Operation and Configuration 21
Alarm Setup
Use this option of the Alarms screen to access the following options:
Alarm Beeper
Use this option of the Alarms screen to turn the alarm beeper ON or OFF.
Loading Limits Configure the following in amps and as a percentage of full load:
• Out High: The upper limit for output current.
• Out Low: The lower limit for output current.
• Out Neut: The upper limit for current on the neutral wire for
the output phases.
Voltage Limits Configure the following as a percentage under or over the rated
voltage:
• Input: The allowed range for input voltage.
• Output: The allowed range for output voltage.
Other Limits Configure these limits:
Frequency: The frequency variation, in hertz, that is
acceptable for the output current.
Global Alarm Config
Set all the loading limits or all the voltage limits simultaneously as
a percentage of full load:
• Load Limits: Set the same percentage for the upper limit for
output current, the lower limit for output current, and the
upper limit for current on the neutral wire for the output
phases. (Use the Loading Limits option to set these
thresholds individually.)
• Volt Lim its: Set the same percentage for the high and low
thresholds for input and output voltage. (Use the Voltage
Limits option to set these thresholds individually.)
Select Apply Now and then YES to implement your changes.