Datasheet

Network Shutdown Module V3
User guide
Network Shutdown Module V3 – User Manual Page 15/53
3 Minimal configuration steps
3.1 Introduction
In this chapter we describe the basic and minimal configuration steps that must be performed before using the
Network Shutdown Module.
The other and optional configuration possibilities are described later
.
3.2 The IP address of the UPS that powers your server.
In the Configuration -> Power device screen, click on the Add button
Adding a power device
Then following screen appears:
Power device settings
From this screen, you can define the following parameters:
• Network Name or IP address of the Network Management Card. This parameter must correspond to the
UPS that powers your machine.
Note:
For multi-UPS configurations, you have the possibility to enter several names or IP addresses (using the
[Add] button). For these advanced configurations, please refer to the Chapter « Multi – UPS systems ».