User manual

G-Type Rack Power Filter: Installation4
Installation
Install the Unit
Install the unit on a flat surface
Remove the mounting brackets.
Attach the stabilizing feet.
Attach the stabilizing feet (included) to the bottom of the unit before
placing it on a flat surface to avoid scratching the surface and to protect the unit.
Install the unit in a rack or enclosure
Use four screws to secure the mounting brackets to the rails in the rack or enclosure.
Connect Utility Power
Connect the unit to utility power
Note: If the unit is connected to utility power, the unit is actively monitoring input power, but
is operating in Standby mode.
Use the utility power cord to connect the unit to utility power. If the unit is functioning properly, the
display will illuminate.