Owners manual

85Rack Power Filter: Device IP Configuration Wizard
Device IP Configuration Wizard
Capabilities, Requirements, and Installation
How to use the Wizard to configure TCP/IP settings
The Device IP Configuration Wizard configures the IP address, subnet mask, and default gateway of one
or more Rack Power Filters or network-enabled devices (devices containing an embedded APC Network
Management Card [NMC]). You can use the Wizard in either of the following ways:
• Remotely over your TCP/IP network to discover and configure unconfigured Rack Power Filters
or devices on the same network segment as the computer running the Wizard.
• Through a direct connection from a serial port of your computer to a Rack Power Filter or device
to configure or reconfigure it.
System requirements
The Wizard runs on Microsoft Windows 2000, Windows Server
®
2003, and Windows XP operating
systems.
Installation
To install the Wizard from a downloaded executable file:
1. Go to www.apc/tools/download.
2. Download the Device IP Configuration Wizard.
3. Run the executable file in the folder to which you downloaded it.