Owners manual

83Rack Power Filter: Administration: General Options
Reset the Rack Power Filter
Path: Administration > General > Reset/Reboot
Configure Links
Path: Administration > General > Quick Links
Select the Administration tab, General on the top menu bar, and Quick Links on the left navigation
menu to view and change the URL links displayed at the bottom left of each page of the interface.
By default, these links access the following Web pages:
• Link 1: The home page of the APC Web site.
• Link 2: A page where you can use samples of Web-enabled products.
• Link 3: The APC download link: http://www.apc.com/download.
To reconfigure any of the following, click the link name in the Display column:
• Display: The short link name displayed on each interface page
• Name: A name that fully identifies the target or purpose of the link
• Address: Any URL—for example, the URL of another device or server
Action Definition
Reboot
Management
Interface
Restarts the interface of the Rack Power Filter.
Reset All
1
Clear the Exclude TCP/IP checkbox to reset all configuration values; mark the Exclude
TCP/IP
checkbox to reset all values except TCP/IP.
Reset Only
1
TCP/IP settings: Set TCP/IP Configuration to DHCP & BOOTP, its default setting,
requiring that the Rack Power Filter receive its TCP/IP settings from a DHCP or BOOTP
server. See “TCP/IP and Communication Settings” on page 60.
Event configuration: Reset all changes to event configuration, by event and by group, to
their default settings.
1. Resetting may take up to a minute.