Owners manual

45Rack Power Filter:
Configuring Outlet settings
Path: Configuration and Control > Configuration > outlets
General information:
• The Power On and Power Off Delay values are not applicable to outlets 1 and 2 and outlet 3.
• Outlet 3 cannot be configured as Controlled by Master.
• Outlets 1 and 2 are non-Switched outlet, and only support Reboot Only.
• Only outlet 4 can be configured as Master.
• Outlets 5 to 8 can be configured as Controlled by Master.
Displaying the outlet configuration parameters:
Under Configuration Summary area, click on outlet name in the Name column, and the configuration
parameters for that outlet display in the bottom half of the screen page.
Configure the outlet setting or outlet name
The following settings are available:
Steps to configure outlet setting or outlet name:
Select the Configuration and Control tab, and then outlet sub-menu under configuration menu from the
left navigation menu.
1. From the Configuration and Control tab, select Configuration and outlets.
2. Enter values for Name, Power On/Off Delay, or Reboot Duration, and select the setting of Outlet
Type from the drop-list option.
3. Click the Apply button.
Configuring the Auto-Reboot feature
When the Auto-Reboot feature is enabled, ProAV will operate in Automatic Reboot mode. In this mode,
ProAV is configured to periodically confirm that another IP device (such as a server, a computer, a
router) is working by sending ping requests to the device.
ProAV expects a response after each ping. If a pre-set number of ping requests fail, it is assumed that the
device is not functioning properly. ProAV attempts to return the device to normal operation by rebooting
it.
In Automatic Reboot mode, you still have the ability to manually reboot the device from a remote
location over the network. When Auto-Reboot feature is disabled, ProAV operates in Normal mode. In
Normal mode, ProAV will only change the state of the outputs when commanded by a user.
Setting Description
Name Set the name for one outlet. The name is displayed next to the outlet
number on status screens.
Outlet Type Set the control type of one outlet
On/Off Delay Set the number of seconds that the Rack Power Filter waits after a
command is issued before applying/Removing power to an outlet.
Reboot Duration Set the number of seconds an outlet remains off before restarting.