Owners manual

7Rack Power Filter: Using the Network Management Card
Command Line Interface
1. Log on to the command line interface. See “Logging on to the Command Line Interface” on
page 11.
2. Contact your network administrator to obtain the IP address, subnet mask, and default gateway
for the Rack Power Filter.
3. Use these three commands to configure network settings. (Text in italics indicates a variable.)
a.
tcpip -i yourIPaddress
b.
tcpip -s yourSubnetMask
c.
tcpip -g yourDefaultGateway
For each variable, type a numeric value that has the format xxx.xxx.xxx.xxx.
For example, to set a system IP address of 156.205.14.141, type the following command
and press E
NTER:
tcpip -i 156.205.14.141
4. Type exit. The Rack Power Filter restarts to apply the changes.