Instruction manual

Pg.9 – Instructions Version 1.1, January 2009
17. Install tailwheel bracket as shown in photo.
18. Install the Elevator CA hinges. Again, test fit
for alignment and slight gap between the
two surfaces. Note: you may wish to flex
hinges back and forth several times before
installation.
19. Temporarily install the wing with long
machine screws and washers.
20. Test fit the tail assembly. Note the elevator
is parallel to the wing and the rudder is
perpendicular to the elevator. Assemble the
tail section using 5-min epoxy. Be careful to
maintain alignment during gluing.