Instruction manual

Pg.7 – Instructions Version 1.1, January 2009
9. With the aileron tight and deflected
downward, use 2 drops per hinge of thin CA
to assure strong bonds. Use paper towel to
remove any excess CA before drying.
10. Deflect aileron upwards and repeat
application for bottom of wing. Note very
small gap between aileron and wing.
11. Using a 90º triangle, mark aileron for
location of control horn as shown in photo.
12. Use tape to hold aileron in neutral position.
Install control horn so that holes in control
horn are in line with the aileron hinge line.
Remove covering under control horn with
hobby knife. Trial fit horns, then use medium
CA or 5-min Epoxy to glue horns in place.