Instruction manual

Pg.5 – Instructions Version 1.1, January 2009
1. Prepare aileron servo mounting plate for
installation. (Note: plywood tab with pull-
string needs to be broken free with needle
nose pliers.)
2. Turn on radio. Make sure the aileron trim is
centered and all programming is reset to
neutral. Install servo arm 90º to the plate
and located in the center of slot. Drill the
outer servo arm hole out to 3/64” (1.2mm)
diameter. This hole is located 1/2” (13mm)
from the center of the servo screw.
3. Attach 12” servo wire extension and secure
with tape or heat shrink tubing.
4. Keep servo aligned per step 2. Mount servo
as shown in photo using supplied hardwood
blocks and screws. Use 5-min Epoxy to
attach blocks.