Instruction manual

Pg.15 – Instructions Version 1.1, January 2009
41. Use your radio manual to set up Elevator
travel and exponential as shown. Adjust
Elevator to get 7/8” (21mm) UP and 5/8”
(16mm) DOWN travel.
Use 25% expo to soften the center travel
per your radio manual. (JR/Spektrum +25%
and Futaba/Hitec -25%)
*This photo shows the measurement from
the elevator neutral position to the full up
position. Repeat for full down elevator.
42. Adjust Rudder travel to get 5/16” (10mm)
LEFT and 5/16" (10mm) RIGHT.
Use 20% expo to soften the center travel
per your radio manual. (JR/Spektrum +20%
and Futaba/Hitec -20%)
*This photo shows the measurement from
neutral to full right rudder. Repeat for full left
rudder.
43. It is recommended to use two channels for
the ailerons, one for the left aileron and one
for the right aileron. Use your radio manual
to help you do this. Adjust each aileron’s UP
travel to get 1/2” (13mm) using end point
adjustment.
44. Adjust each aileron’s DOWN travel to get
1/8” (4mm) using the end point adjustment.
If your radio has a differential function, you
may use that instead. Use 20% expo to
soften the center travel per your radio
manual. (JR/Spektrum +20% and
Futaba/Hitec -20%)