Instruction manual

Pg.14 – Instructions Version 1.1, January 2009
37. Insert the cable through the crimp tube, then
the fuselage bracket, and finally back
through the crimp tube. Carefully pull tight
and crimp the tube using needle nose pliers.
Trim off excess wire.
38. Route cable thru tail as shown, making a
diamond shape.
39. Insert cable through second crimp tube,
fuselage bracket, and back through crimp
tube. Carefully pull snug and crimp with
needle nose pliers. Trim off excess as
shown. Do not over-tighten. Tail brace wires
are for scale appearance only.
40. Mark the CG on each wing at 1-3/4”
(45mm) back from the leading edge. Install
battery and balance model at these marks
with the tips of your fingers. Move the
battery fore or aft until airplane balances
with fuselage level or slightly nose down.
Make a mark in battery compartment so that
you place the battery in the same place
every time. Small stick-on lead weights may
also be necessary inside engine cowl or
near tail to properly balance.