Instruction manual

Pg.13 – Instructions Version 1.1, January 2009
33. Install wing struts to fuselage using sheet
metal screws.
34. Install landing gear / wing strut cover with
sheet metal screw.
35. Make sure to support the wing center
section with foam block (approx. 7/8” tall) or
small towel. Be careful not to twist wing or
apply too much pressure. Carefully install a
screw into each wing strut as shown in
photo. Note: The wing dihedral is 2 degrees.
With plane upright and level, the height
difference between the root rib (next to the
fuselage) and the last full rib (the outer end
of the aileron) is about 3/4" for each wing
panel.
36. Locate the cable and crimp tubes for the tail
flying wires.