Instruction manual

Pg.12 – Instructions Version 1.1, January 2009
29. Install servo wires into your receiver. Make
sure all items are secure for flight. Install
wing with machine screws and washers.
30. Install windshield with (4) sheet metal
screws.
31. Install cowling with (4) sheet metal screws.
Make sure the propeller has about 1/8”
clearance from the front of the cowling.
Install APC 9x6 “E-series” propeller.
32. Use a small foam block (approximately 7/8”
tall) or towel to support center wing section
with wingtips touching building table. Sight
across the wings to check for twist and
warp. You may also use an “incidence
meter” to check for zero twist in Left and
Right wing panels. If found, twist wing into
desired position and remove new wrinkles in
covering with iron or heat gun. Experienced
builders may also add 1 degree of washout.