Instruction manual

Pg.11 – Instructions Version 1.1, January 2009
25. Install the landing gear using the nylon
straps and sheet metal screws.
26. Install the wheels with a wheel collar on
each side of each wheel. (Battery hatch
shown installed with magnets in this photo.)
27. Solder connectors to motor, electronic
speed control (ESC), and battery. Install
motor on firewall per your motor’s instruction
manual. Right and down thrust is already
built into firewall, so you can mount motor
flat against firewall.
28. Insert ESC into space above battery tray
and route battery connector through
lightening hole. Install Velcro to hold battery
in place. You should run some CA around
the edges of the Velcro to help stick to
plywood. (Note: the airplane is upside down
in this photo; you are looking toward the
tail.)