User manual

- 4 -

Side Panel Indicators

The following section describes the LED indicators on the

C2C’s side panel. The side panel controls and indicators for the

C2C Power Filter are detailed in Figure 2. Each numbered callout

refers to a corresponding numbered description found

immediately below the picture.

Figure 2. C2C Side Panel Indicators

Wiring OK Status Indicator

When it is on (lit) it indicates the receptacle the C2C is

plugged into is live and wired properly. If it is off (not lit),

one of three wiring problems exists in the building wiring

circuit: missing ground, overloaded neutral, or reversed

polarity.

An electrician should be consulted to resolve the problem.

Protection Working Status Indicator

When on (lit), it indicates the C2C is functioning properly.

If it is off (not lit), the C2C has been hit by a surge, and the

protection circuitry may be damaged.

Filtering Status Indicator

When this indicator is on (lit) it indicates that the EMI/RFI

noise reduction circuitry is active.