How to Guide

Class B Labeling and

Instruction Manual Requirements

Devices subject to Certification must be labeled with an FCC Identifier.

Devices subject to Verification or Certification must be labeled with the fol-

lowing compliance statement:

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) this device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

In addition, for a Class B digital device or peripheral, the instructions fur-

nished the user shall include the following or similar statement, placed in

a prominent location in the text of the manual:

Warning: Changes or modifications to this unit not expressly

approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part 15 of

the CC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installa-

tion. This equipment generates, uses, and can radiated radio

frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interfer-

ence will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one

or more of the following measures:

Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and

receiver.

– Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

– Consult the dealer or an experienced audio TV technician

for help.

If shielded cables or other specialized accessories are necessary for the

unit to achieve compliance, a statement similar to the following should be

added:

Shielded cables must be used with this unit to ensure compli-

ance with the Class B FCC limits.