How to Guide

- 7 -

Installation

C2/C2-CN installation consists of the following steps:

1. Apply power

2. Making connections

Apply Power

Prior to connecting equipment to the C2/C2-CN Power Filter,

ensure the unit is functioning by connecting the AC Power Cord

(provided), shown as in Figure 2. When power is applied to

the unit, it will automatically power up, and the side panel LEDs

will illuminate, indicating that the unit is receiving power.

Making Connections

Connect the equipment to the two outlets shown in Figure 3.

FCC Compliance Information

This device complies with Part 68 and Part 15 of the Federal

Communications Commission (FCC) rules. Operation is subject

to the following two conditions: (1) This device must not cause

harmful interference, and (2) This device must accept any

interference received, including interference that may cause

undesired operation. As required, the bottom of this equipment

contains, among other information, the Registration Number and

Ringer Equivalence Number (REN) for this equipment. If

requested, this information must be provided to the telephone

company.