Installation Guide

Back-UPS Pro BX850/1000/1350/1500M/M-LM608
Full-Time/
Power-Saving
mode
2 On The LCD will illuminate and the
Back-UPS will beep to confirm the
Full-Time mode. The LCD will darken
and the Back-UPS will beep to
confirm the Power-Saving mode.
While in Power-Saving Mode, the
LCD will illuminate if a button is
pressed, then darkens after 60 seconds
of no activity.
Mute
General Status
Enable/Disable
2 On Enable or disable the audible alarms.
The Mute icon will illuminate and the
Back-UPS will beep one time. The
Mute function will not activate unless
the Back-UPS is operating on battery
power.
Sensitivity
6 Off The Load Capacity icon will blink,
indicating that the Back-UPS is in
programming mode. Use the
POWER
button to scroll through Low, Medium,
and High, stop at selected sensitivity.
The Back-UPS will beep to confirm
selection. See "Unit sensitivity" for
details.
Self-Test
(manual)
6 On The Back-UPS will perform a test of
the internal battery. Note: This will
happen automatically when the
Back-UPS is turned ON or when the
Back-UPS previously detected a bad
battery.
Event Reset
0.2 On When the Event screen is visible, press
and hold DISPLAY, then press POWER
button, to clear the detected error event
counter.
Error Reset
2 Error After an error has been identified,
press
POWER buttonto remove the
visual indication and return to standby
status.
Function Button
Timing
(seconds)
UPS
Status Description