Specifications

Back-UPS BR1000G-BR Installation and Operation6
Warnings and System Faults
Audible Warnings
Warning Icons
System Faults
The Back-UPS will display these fault messages.
Four Beeps Every 30 Seconds
Back-UPS is running on battery. You should consider saving any work in progress.
Continuous Beeping
Low battery condition and battery run-time is very low. Promptly save any work in progress, exit
all open applications, and shut down the operating system.
Continuous tone
Battery Backup outputs are overloaded.
Chirps for 1 Minute every 5 hours
Battery fails the automatic diagnostic test and should be replaced.
If these icons are
illuminated... This may be the problem.
The Back-UPS is operating on A/C power, but is overloaded. Disconnect one of the devices connected to
the Back-UPS. If the Overload icon stops flashing, the Back-UPS is no longer overloaded and will
continue to operate normally.
The Back-UPS is operating on battery power, but is overloaded. Disconnect one of the devices connected
to the Back-UPS. If the Overload icon stops flashing, the Back-UPS is no longer overloaded and will
continue to operate normally.
The Back-UPS is operating on A/C power, but the battery is not functioning properly.
Contact APC Customer Service to order a replacement battery.
See “Replacement Battery” on page 9.
The Back-UPS is operating on battery power and the battery power is getting low. Shut down all
connected equipment to avoid losing unsaved data. When possible, connect the Back-UPS to A/C power
to recharge the battery.
F01
On-Battery Overload Turn the Back-UPS off. Disconnect non-essential equipment from
the Battery Backup outlets and the turn Back-UPS on.
F02
On-Battery Output Short Turn the Back-UPS off. Disconnect non-essential equipment from
the Battery Backup outlets and the turn Back-UPS on.
F03
On-Battery Xcap Overload
Faults F03-F09 cannot be corrected by the user. Contact APC
Technical Support for assistance.
F04
Clamp Short
F05
Charge Fault
F06
Relay Welding
F07
Temperature
F08
Fan Fault
F09
Internal Fault
bu088a