User's Manual
Table Of Contents
- Safety and General Information
- Inspect the package contents upon receipt. Notify the carrier and dealer if there is any damage.
- SAVE THESE INSTRUCTIONS - This section contains important instructions that should be followed during installation and maintenance of the UPS and batteries.
- Inventory
- Connect the Battery
- Specifications
- Connect Equipment
- Turn On the Back-UPS
- Turn Off the Back-UPS
- Quick Mute
- On Battery Indicator Modes
- Voltage Sensitivity Adjustment (optional)
- Status Indicators
- Troubleshooting
- Wall Mount Installation
- Service
- Battery Replacement
- Warranty
- Register your product on-line. http://warranty.apc.com
- APC by Schneider Electric IT Customer Support Worldwide
- EMC Compliance
- WARNING! Handling Safety
- WARNING! Deenergize Safety
- WARNING! Electrical Safety
- WARNING! Battery Safety
- User Manual Back-UPS™ BE425M/425M-LM, BN450M/450M-CA
- Safety Information - SAVE THIS GUIDE
• The ground conductor must be grounded to earth at the service equipment, or if
supplied by a separately derived system, at the supply transformer or motor gen-
erator set.
• Connect the equipment to a three wire utility outlet (two poles plus ground). The
receptacle must be connected to appropriate branch circuit/mains protection (fuse
or circuit breaker). Connection to any other type of receptacle may result in risk
of electrical shock.
• Leakage current for a pluggable Type A UPS may exceed 3.5 mA when a sepa-
rate ground terminal is used.
WARNING! Battery Safety
• This equipment contains potentially hazardous voltages. Do not attempt to disas-
semble the unit. The only exception is for a UPS containing user replaceable bat-
teries. Refer to the battery replacement procedures detailed in the user manual.
• Do not dispose of batteries in a fire. The batteries may explode.
• Do not open or mutilate batteries. They contain an electrolyte that is toxic and
harmful to the skin and eyes.
• Replace batteries with the same number and type of batteries as originally
installed in the equipment.
EN 990-2827F-001
06/2014
© 2014 APC by Schneider Electric. APC, the APC logo, and Back-UPS
are owned by Schneider Electric Industries S.A.S., or their affiliated
companies. All other trademarks are property of their respective owners.