User Manual

Back-UPS Pro 500 BG500 120 Vac6
To Download Device IP Configuration from the APC Website.
1.Go to www.apc.com/tools/download.
2.Download the Device IP Configuration Wizard.
3.Run the executable file in the folder from where it was downloaded. Go back to Step 4 under the Installation of the
Device IP Config Wizard section.
Use the Device IP Configuration Utility. Once
installed, the Device IP Configuration Utility will determine
the IP Address assigned to your Back-UPS Pro by your
network.
1. Start the Device IP Configuration Utility. The program
can be found using Start -> Programs -> Schneider-
Electric -> Device IP Configuration Utility (A version
number may be included at the end of the file name).
2. You should be on the first tab “Find Devices On
Network” in the Wizard and enter the IP range to search.
The first 3 IP segments left should be the same to the
TCP/IP settings of your computer, the 4th segment is
usually 1 for the Starting IP and is 254 for the Ending IP.
The values should automatically be entered for you if
your computer’s network interface is working properly.
Click Start Search to begin.
Note: Both PC and UPS must be connected to the same router even if the PC is in a wireless network.
3.After the Back-UPS Pro has searched the network, the
Back-UPS Pro unit should be listed in a table within the
Utility. Click on its IP Address to access the management
interface. If you have multiple Back-UPS units or other
network manageable APC UPS’es there may be multiple
entries, match the MAC Address on the black tab in the
battery door of the Back-UPS Pro to the MAC Address
listed in the utility. Click this IP Address to access the
management interface. Bookmark this IP Address and
save it for future reference.

Click on Install. Click Finish to complete the utility installation.
bu273a
bu274a
bu275a
bu276a