User Manual

Back-UPS BE650G2-RS/BE850G2-RS
11
Replace Battery
Replacement batteries can be ordered through the APC by Schneider Electric
Web site, www.apc.com. .
Troubleshooting
CAUTION
RISK OF HYDROGEN SULPHIDE GAS AND EXCESSIVE SMOKE
• Replace the battery atleast every 5 years.
• Replace the battery immediately when the UPS indicates battery
replacement is necessary.
• Replace battery at the end of its service life.
• Replace batteries with the same number and type of batteries as
originally installed in the equipment.
• Replace the battery immediately when there is evidence of
electrolyte leakage. Power off the UPS, unplug it from the AC input,
and disconnect the batteries. Do not operate the UPS until the
batteries have been replaced.
Failure to follow these instructions could result in minor or
moderate injury and equipment damage.
Model Replacement battery part number
BE650G2-RS APCRBC110
BE850G2-RS RBC17
Deliver the used battery to a recycling facility.
Problem Possible Cause Corrective Action
The Back-UPS
will not turn on.
The Back-UPS has not been
turned on.
Press the POWER ON/OFF button.
The Back-UPS is not
connected to utility power, or
there is no utility power
available at the wall outlet, or
the utility power is
experiencing a brownout or
over voltage condition.
Be sure that the power cord is securely
connected to the wall outlet, and that
the utility power is available at the wall
outlet.Where applicable, be sure that
the wall outlet is switched on.