Specifications

Back-UPS Pro 500 BG500 120 Vac24
Use the Device IP Configuration Utility. Once
installed, the Device IP Configuration Utility will
determine the IP Address assigned to your Back-UPS
Pro by your network.
1. Start the Device IP Configuration Utility. The
program can be found using Start -> Programs ->
Schneider-Electric -> Device IP Configuration
Utility (A version number may be included at the
end of the file name).
2. You should be on the first tab “Find Devices On
Network” in the Wizard and enter the IP range to
search. The first 3 IP segments left should be the
same to the TCP/IP settings of your computer, the
4th segment is usually 1 for the Starting IP and is
254 for the Ending IP. The values should
automatically be entered for you if your computer’s network interface is working properly. Click Start Search
to begin.
Note: Both PC and UPS must be connected to the same router even if the PC is in a wireless network.
2a. On rare occasions the IP Address may not populate
properly as seen in the graphic on the right.
If the first 3 entries are 0 then you must obtain your
network IP address by using the Run command in Windows.
a) Press the Windows Key + r
b) Type 'cmd' in the window that pops up
(leave out the apostrophe)
c) In the command window type 'ipconfig'
bu275a
bu344a
bu346a
bu345a