Specifications

Installation and Operation Back-UPS 1250, 1300, 1500 11
Specifications
Service
If the unit requires service, do not return it to the dealer. Follow these steps:
1. Review the Troubleshooting section of the manual to eliminate common problems.
2. If the problem persists, contact APC Customer Support.
a. Note the model number and serial number and the date of purchase. The model and serial
numbers are located on the rear panel of the unit and are available through the LCD display
on select models.
b. Call APC Customer Support and a technician will attempt to solve the problem over the
phone. If this is not possible, the technician will issue a Returned Material Authorization
Number (RMA#).
c. If the unit is under warranty, the repairs are free.
d. Service procedures and returns may vary internationally. Refer to the APC Web site for
country specific instructions.
3. Pack the unit properly to avoid damage in transit. Never use foam beads for packaging. Damage
sustained in transit is not covered under warranty. Always DISCONNECT THE UPS
BATTERY before shipping in compliance with U.S. Department of Transportation (DOT)
and IATA regulations. The battery may remain in the unit.
4. Write the RMA# provided by Customer Support on the outside of the package.
5. Return the unit by insured, pre-paid carrier to the address provided by Customer Support.
Model 1500 VA 1300 VA 1250 VA
Maximum Load 865 W 780 W 750 W
Nominal Input Voltage 120 Vac
Online Input Voltage Range 88 Vac to139 Vac
Automatic Voltage Regulation + 11.5% Boost Only
Frequency Range 50/60 Hz ± 1 Hz
On battery Waveshape Step approximated sinewave
Typical Recharge Time 16 hours
Transfer Time 8 ms, maximum
Operating Temperature 0
º
to 40
º
C (32
º
to 104
º
F)
Storage Temperature -5
º
to 45
º
C23
º
to 113
º
F (23
º
to 113
º
F)
Unit Dimensions 11.9 × 4.4 × 15.0 in (30.1 × 11.2 × 38.2 cm)
Unit Weight 23.8 lbs (10.8 kg) 22.8 lbs (10.4 kg)
Interface USB
On Battery Runtime Go to: http://www.apc.com/product
EMI Classification FCC / DOC Class B Certified