Owner`s manual

Configuration
Supported
configurations
Two supported configurations for Redundant Switch are shown
below. For more information on these and other supported
configurations, visit the
APC
Web site .
Configuring
PowerChute
plus
1. Install PowerChute
plus
as described in the enclosed
software installation instructions.
2. For Source B:
a. At the Redundant Switch front panel, set the Source
Preference to Source
B
.
b. Start the computer on which PowerChute
plus
is
installed.
c. Start PowerChute
plus
. Communication is to
UPS
-
B
.
d. Configure
UPS
-
B
according to your requirements.
e. Set the
UPSID
to
UPS_B
.
3. For Source A:
a. At the Redundant Switch front panel, set the Source
Preference to Source
A
.
Note
Install only
SNMP
accessories in the
UPS
. You
must install any other accessories in the
Redundant Switch
Both
UPS
s must be the same sine-wave model.
Minimum acceptable
configuration:
Redundant Switch
with two Smart-UPS units
connected to one
AC
line (the same
facility power source).
Best configuration:
Redundant
Switch
with two Smart-UPS units
connected to two separate
AC
lines
(each
UPS
receiving power from a
separate facility power source).