User`s guide

®
USER’S GUIDE AUTOMATIC TRANSFER SWITCH
86
Syslog
By default, the Automatic Transfer Switch can send messages to up to four
syslog servers whenever Automatic Transfer Switch or embedded
management card events occur. The Syslog servers, which must be
specifically identified by their IP addresses or domain names, record the
events in a log that provides a centralized record of events that occur at
network devices.
Syslog settings. Leave the Syslog settings, except the Server IP settings,
set to their defaults unless otherwise specified by the Syslog network or
system administrator.
See also
This user’s guide does not describe Syslog, or the Syslog
configuration values, in detail. For more information about
Syslog, see RFC3164, available at www.ietf.org/rfc/
rfc3164.
General Settings
Setting Definition
Syslog Enables (by default) or disables the Syslog feature.
Facility Selects the facility code assigned to the Automatic Transfer Switch’s
Syslog messages (User, by default).
N
OTE: Although other selections are available, User is the selection
that best defines the Syslog messages sent by a Automatic Transfer
Switch.