User`s guide

USER’S GUIDE

AUTOMATIC TRANSFER SWITCH

URL address formats

Type the DNS name or IP address of the Network Management Card in the

Web browser’s URL address field and press E

NTER. Except as noted

below, http:// is automatically added by the browser.

• For a DNS name of Web1, the entry would be one of the following:

– http://Web1 if HTTP is your access mode

– https://Web1 if HTTPS (SSL) is your access mode

• For a System IP address of 198.168.6.133, when the Network

Management Card uses the default port (80) at the Web server, the

entry would be one of the following:

– http://198.168.6.133 if HTTP is your access mode

– https://198.168.6.133 if HTTPS (SSL) is your access mode

For a System IP address of 198.168.6.133, when the Network Management

Card uses a non-default port (5000, in this example) as the Web server, the

entry would be one of the following:

– http://198.168.6.133:5000 if HTTP is your access mode

– https://198.168.6.133:5000 if HTTPS (SSL is your access

mode)

Note

If the error “You are not authorized to view this page” occurs

(Internet Explorer only), someone is logged onto the Web interface

or control console. If the error “No Response” (Netscape) or “This

page cannot be displayed” (Internet Explorer) occurs, Web access

may be disabled, or the Network Management Card may use a

non-default Web-server port that you did not specify correctly in

the address. (For Internet Explorer, you must type http:// or

https://as part of the address when any port other than 80 is

used.)