User`s guide

®
USER’S GUIDE AUTOMATIC TRANSFER SWITCH
21
Web Config
The Web Config option provides pass-through access to the Network
Management Card. When you select Web Config, a screen will prompt you
to change your terminal emulator settings to a baud rate of 2400 bps. When
you are finished configuring the Network Management Card, it will also
remind you to reset the Automatic Transfer Switch and change the baud
rate back to 19200 .
To access Network Management Card through the serial port:
1. Disconnect your terminal program.
2. Change the baud rate to 2400 bps and reconnect the terminal program.
3. Press
ENTER to display the log on prompt for the Network Management
Card.
After you have finished using the menus of the Network Management Card,
reset the terminal settings to return to the Automatic Transfer Switch
internal menus.
4. Disconnect you terminal program.
5. Change the baud rate back to 19200bps.
6. Press and hold the Preference button on the front of the Automatic
Transfer Switch until all the LEDs (except the output LED) turn off (in
about ten seconds).
7. Reconnect the terminal program and log on to the internal menus.
Note
The Front Panel Select option on the Switch Configuration
menu must be set to Unlocked. Otherwise, the Preference
button will not reset the Automatic Transfer Switch.