User`s guide

®
USER’S GUIDE AUTOMATIC TRANSFER SWITCH
169
3. Type open and the Automatic Transfer Switch’s IP address, and press
ENTER. If the Port setting for FTP Server in the Network menu has
changed from its default of 21, you must use the non-default value in the
FTP command.
a. For some FTP clients, use a colon to add the port number to the end
of the IP address.
b. For Windows FTP clients, separate the port number from the IP
address by a space. For example, if the Automatic Transfer Switch’s
FTP Server Port setting has been changed from its default of 21,
such as to 21000, you would use the following command for a
Windows FTP client transferring a file to a Automatic Transfer
Switch with an IP address of 150.250.6.10.
ftp> open 150.250.6.10 21000
4. Log on using the Administrator user name and password. (apc is the
default for both.)
5. Upgrade the AOS. For example:
ftp> bin
ftp> put apc_hw02_aos_264.bin
6. When FTP confirms the transfer, type quit to close the session.
7. Wait 20 seconds, and then repeat step 2 through step 6, but in step 6, use
the application module file name instead of the AOS module.