User`s guide

®
USER’S GUIDE AUTOMATIC TRANSFER SWITCH
152
Use the Wizard
Launch the Wizard
The installation creates a shortcut link in the Start menu that you can use to
launch the Wizard.
Configure the basic TCP/IP settings remotely
Prepare to configure the settings. Before you run the Wizard, be sure
that you have the information you will need during the configuration
procedure:
1. Contact your network administrator to obtain valid TCP/IP settings to
use.
2. If you are configuring multiple unconfigured Network Management
Cards, obtain the MAC address of each one so that you can identify
each Network Management Card that the Wizard discovers. (The
Wizard displays the MAC address for a discovered card on the same
screen on which you then enter the TCP/IP settings.)
• For Network Management Cards that you install, the MAC address is
on a label on the bottom of the card.
• For embedded Network Management Cards, the MAC address is on a
label on the device containing the card — for example, usually on the
side of a device that you mount in a rack.
You can also obtain the MAC address from the Quality
Assurance slip that came with the Network Management
Card or with the device containing an embedded Network
Management Card.