User manual

A-3
Press the System Setup button to display the next message.
Reset Energy Meter
System Test
GEN Source Type
Generator Power Rating
For example, a typical standby generator designed for the home, and rated at 5000 Watts peak/surge, may
only have a continuous rating of 4000 Watts. The UTS intelligent adaptive load management (ALM)
algorithm tries to optimize the average power output of the generator, and the continuous rating is the most
appropriate to use.
Note
MAXIMUM OFF and MINIMUM ON times are set separately for each circuit.
This feature allows you to determine the total electric energy
that is being consumed by your loads in kilowatt hours (kWh).
When it is reset, the kWh counter for each circuit resets to 0,
and counts from that point forward.
Press the
System Setup button to display the next message.
System test can be set to
NO or YES. Setting it to YES initiates
system test, which checks UTS basic operation and related
components.
Press the
System Setup button to display the next message.
This feature allows you to select the type of power source that
is connected to the UTS Generator Inlet.
The default is
GENERATOR.
Press the
System Setup button to display the next message.
This display, and the
Down Arrow and Up Arrow buttons are
used to set the maximum power rating for the generator.
Press the
System Setup button to display the next message.
Note For typical generators you should enter the generator’s maximum continuous
power rating, not its peak or surge rating.
!
RESET ENERGY METER:
YES/NO
SYSTEM TEST:
NO/YES
BACKUP1 SOURCE TYPE
GENERATOR/UPS/OTHER
GEN POWER RATING:
0-12000W
!