User manual

A-1
Appendix A
Advanced Configuration
Advanced Configuration and Setup
Advanced configuration and setup consists of two major tasks, system configuration and setup, and circuits
configuration and setup.
System Configuration and Setup
Press the SYSTEM SETUP button to enter system setup mode. The LCD setup messages will appear in the
order they are described in this section. The Up Arrow and Down Arrow buttons are used to move between
messages, and to change values.
Bypass Mode
This mode can be disabled by selecting NO, or enabled by selecting YES. The factory default is NO.
Press the
System Setup button to display the next message.
Note The settings or values will change immediately after a Down Arrow or Up Arrow
push button is pressed.
In
BYPASS MODE, all circuits are powered by the utility
power source. Backup sources are not used to power the
loads regardless of the status of the primary utility power
source.
Note Changing Bypass settings while on Utility will cause all loads to be momentarily
disconnected.
Other protections such as over voltage and under voltage protection are not
available in Bypass mode. However, overload protection is provided.
!
BYPASS MODE:
NO/YES
!