User manual

3-4
Circuit Status
Pressing the Circuit Status button allows you to display additional details about each of the
circuits. An example is provided below:
The following table is a summary of the types of source states, and power status informational
messages that are displayed on the LCD.
Summary of Source States and Informational Messages
This message contains the MODEL# (model number)
and SN# (serial number) of your UTS.
This message provides the firmware version (FW VER)
that is used in your UTS.
This message shows the date your UTS was
manufactured (MFG DATE).
In this example, CK1SRC (Circuit 1 Source) indicates
the power source plus the status of Circuit1: 1 Amp, 2.35
kWh, and 120 Watts.
CK2SRC (Circuit 2 Source) would indicate the power
source, and would contain status information similar to
that shown for CK1SRC above.
Source(s) Description
UTILITY
When this is displayed it indicates that power is supplied from the normal utility source.
STANDBY
Indicates that the circuit is in standby mode, and is not receiving power.
GEN
This indicates the circuit is powered by a generator.
UPS
This indicates the circuit is powered by a UPS.
BYPASS
This indicates the circuit is being bypassed to the utility power. When the UTS is in the
bypass state (which applies to the whole system) the UTS always supplies power directly
from the utility to all the circuits, regardless of the power’s quality or condition.
FAULT
This indicates the circuit has a fault, and additional messages are used to display more
specific fault information.
MODEL#: UTS10BI
SN#: JB06008004272
UTS FW VER: 1
UI FW VER: 1
MFG DATE:07/23/2006
CK1SRC:UTILITY AMP:1
KWH:2.35 WATTS:120