User manual

3-3

System Status

The UTS system status, and the status of up to three power sources can be viewed by pressing the

System Status button. The messages are displayed in sequential order beginning below, with a

brief description of each message.

Circuit Indicators (Red) Depending on the UTS model there can be up to ten red LED indicators

located on the front panel under Circuit that show the status of the circuits

being backed up by the UTS.

When one of the LEDs is ON (lit) it indicates that circuit is receiving power

from one of the power sources.

When a LED is OFF (not lit) it indicates that circuit is not receiving power.

When a LED is flashing OFF and ON it indicates that a fault or abnormal

condition exists that should be corrected.

This message contains the AC input voltages from the

UTILITY via the main load center for PHASE1 and

PHASE2.

This message shows the SYSTEM LOAD (total power)

that is being drawn through the UTS, which is further

divided into the power drawn by each phase - PH1 and

PH2. This information is especially useful for verifying

that the phases are balanced

This message displays the BACKUP1 source voltages

for GEN PHASE1 and GEN PHASE2.

This message shows the BACKUP1 source power

outputs for GEN PHASE1 and GEN PHASE2.

This message includes the UPS VOLTAGE and UPS

LOAD (power) for the BACKUP2 source (normally the

UPS).

UTILITY PHASE1: 120V

UTILITY PHASE2: 120V

SYSTEM LOAD: 2400W

PH1: 1050W PH2: 1350W

GEN PHASE1: 117V

GEN PHASE2: 118V

GEN PHASE1: 480W

GEN PHASE2: 750W

UPS VOLTAGE: 120V

UPS LOAD: 200W