User manual

3-1

Chapter

Controls and Indicators

This chapter describes and illustrates the controls and indicators that are used to setup, configure

and operate the UTS6, UTS6BI and UTS10BI Universal Transfer Switches (UTSs). The controls

are six push buttons, which are used with LED indicators, and text messages displayed on a liquid

crystal display (LCD), as shown in Figure 3-1. The LCD displays two lines of text, 20 characters

per line.

The various status and informational messages, and system operations that are used during

installation, initial power on and setup are also discussed in Chapter 3 of the Universal Transfer

Switch Site Preparation and Installation Guide (Document No. 990-2992A). Another site

preparation and installation related document is the UTS Quick Install Guide (Document No.

990-3061A).

This chapter discusses the following major topics:

• LCD, push buttons and LED indicators

• System Status

• Circuit Status

• Advanced Configuration