Datasheet

5/11
Table 4: Installation Procedure for J1451A/B, J1452A/B, J1491A
Step Action Figure
Remove the slides from the server shelf assembly:
1 Place the shelf assembly on the
floor and extend the slides to their
full length (J1451 shown).
2 Remove the front and middle M4 ×
6mm slide screws.
3 Move the middle section of the
slide forward until the rear screw
head is visible through the large
hole in the slide. Remove the M4 ×
6mm screw through the hole.
Repeat this procedure for the
remaining slide.
Determine the mounting location of the bezel:
4 Place the bezel (J1451 shown)
against the vertical mounting rails
at the location you have chosen for
your server(s). The bottom of the
bezel should align with the bottom
of a U (one mounting hole below a
notched mounting hole). Using a
pencil, mark the locations of the
two upper bezel mounting holes on
the corner posts. Mark the location
of the lower edge of the bezel on
both of the vertical mounting rails.
Remove the bezel and place it
aside.
Side View
Rear screw visible through hole
in middle section of slide.
Front
Middle
Rear
Align top of
bezel here
Bezel
mounting
hole
Bottom edge
of bezel
Bezel