Datasheet

4/11
Section 2 — Mounting Instructions for J1451A/B, J1452A/B, J1491A
To install J1451A/B, J1452A/B, or J1491A into an APC NetShelter, follow the steps in Table 4.
Note: Your shelf and bezel might vary from the ones shown in the table.
If the slides are not attached to the shelf, skip ahead to Step 4.
4 Tilt the shelf slightly as you place it
in the rack to avoid hitting the
screws that protrude from the sides
of the shelf.
5 Align the rear slots of the shelf with
the 10-32 × 1/2" Torx screws
installed in Step 3. Slide the shelf
along the screws until the front is
flush with the front vertical rails.
Attach one 10-32 × 1/2" Phillips
head screw through each inside
mounting hole located near the front
of the shelf, and tighten. Tighten the
screws along the back grooves of
the shelf.
6 Follow the procedures in the HP
NetServer Rack Mount Kit instruc-
tions to mount the server(s) and ears
(optional) to the shelf.
Note
: You will need to use M6 ×
18mm screws, M6 cup washers, and
M6 caged nuts in the top and bottom
holes of the ears, in place of HP-
supplied Timmerman nuts and deco-
rativescrews.Themiddleholeis
inaccessible.
Table 3: Installation Procedure for J1456A and J1496A
Step Action Figure