Datasheet

10/11
2 If you plan to install the cable
management of the LXr Pro: attach
the mounting block to the rear end
of a mounting rail with one 6-32 ×
3/8" flat head screw.
3 Mount the slide/rail assemblies to
the vertical mounting rails of the
NetShelter, using the M6 × 12mm
slotted screws. Use two screws in
the front of the mounting rail—
one in the bottom mounting hole
and one in the third-from-bottom
mounting hole. Make sure that the
mounting rail is level. On the rear
end of each mounting rail, insert
the screws into both holes.
Note: If you used the mounting
block in Step 2, use two (2) 10-32
× 3/4" Phillips screws at the rear
of the bracket with the mounting
block.
4 Attach the shelf to the rail/slide
assembly. Follow the instructions
in the HP LXr NetServer Pro
Series User Guide, Mounting the
NetServer in a Rack, Installation
Procedure, Step 2: Attaching the
Base to the Rails.
Table 6: Installation Procedure for LXr Pro
Step Action Figure