manual

Part 1 (x1) Part 2 (x1)

™

Inventory

AR4601 - Bolt Down Kit

Installation

For use with Netshelter CX 38U

Models AR4038 & AR4038i

Slide Part 1 of the Bolt Down Kit into place over the

bolts, ensuring the slotted vertical surface is to the rear.

Re-fix the two nuts, leaving out the washers.

Make sure the nuts are tight.

Locate the two available bolts & nuts as shown

under the front of the NetShelter CX

Remove the two nuts and put to one side

PAGE 1
™ AR4601 - Bolt Down Kit Inventory x1 x2 x2 Part 1 (x1) Part 2 (x1) Installation For use with Netshelter CX 38U Locate Models the two available & nuts as shown AR4038 bolts & AR4038i under the front of the NetShelter CX Slide Part 1 of the Bolt Down Kit into place over the bolts, ensuring the slotted vertical surface is to the rear. Remove the two nuts and put to one side Re-fix the two nuts, leaving out the washers. Make sure the nuts are tight.
PAGE 2
Fix Part 2 of the Bolt Down Kit to the floor using appropriate wood, masonry or machine screws. Connect the two Parts together using either the Nuts, washers and winged bolt provided, or using a lock if you prefer. Wheel your CX into place such that the two Bolt Down Kit Parts meet and the slots line up. Fit the stabilizing feet, and then the sides and front of the plinth apron into place. Your CX is now locked into place.