Datasheet

NetShelter VL Enclosure—Unpacking, Installation, and Customization 8
Installation
Installing the Enclosure
Leveling the enclosure
Level the enclosure before installing equipment.
The leveling feet at the corners provide a stable base if the floor is uneven, but they cannot compensate
for a badly sloped surface. You can remove the casters (not provided) and leveling feet to allow the base
of the enclosure to rest directly on the floor.
1. Move the enclosure to a level location.
2. For each leveling foot, insert a Phillips or
slotted screwdriver (not provided) into the
screw above the leveling foot. Turn the
screw clockwise to extend the leveling foot
until it makes firm contact with the floor.
Note: If the enclosure needs to be leveled after equipment has been installed, use a 13-mm
open-ended wrench (not provided) to lower the leveling feet. For each leveling foot, fit the
13-mm end of the open-ended wrench to the hex head just above the round pad on the bottom
of the foot. Turn the wrench clockwise to extend the leveling foot until it makes firm contact
with the floor.
APC offers the following options for leveling the enclosure.
Product SKU Description Figure
Caster kit AR7719
Attaches externally to the
enclosure to provide
additional stability and
mobility.
ns1468a