Datasheet

10 NetShelter VX Four-Post Open Frame—User’s Manual
Installing the Four-Post Open Frame
Removing the
casters and
leveling feet
(optional)
1. Lay the frame on its side.
2. Remove the four hex nuts from each of the casters and
remove the casters.
3. Fit the 14-millimeter end of the open-ended wrench
(included) to the hex head just above the round pad on
the bottom of the leveling foot. Turn the wrench
clockwise to extend the leveling foot until it comes off.
4. Repeat step 3 for each of the remaining leveling feet.
Stabilizing kits
(optional)
American Power Conversion offers additional products (not
included) for stabilizing frame:
• Stabilizer Plate Kit (
AR8115 or AR8115BLK)— one
plate and mounting hardware for attaching to the frame.
Use up to 3 plate kits to provide stability to the front and
sides. You can also bolt stabilizer plates to the floor for
additional stability.
W
arn
i
ng
To avoid personal injury or damage to
the frame, two people should support
the frame.
N
ote
To use the Stabilizer Plate Kit, you must
first remove the front skirt of the frame. See
“Removing the skirts” on page 16.
NS UM 990-0398.book Page 10 Tuesday, February 12, 2002 10:26 AM